MOSFET REG CAN-AM OUTLANDER 500-1000 10-18

 

Why use Mosfet Enhanced technology?

 

 

Runs cooler

Runs much cooler than the traditional Shunt voltage regulator rectifier.

Saves gas

Less load on the stator, less work, less fuel is used and you save.

Regulated energy

The power charging your battery is steadier and smooth.

Extended battery life

Extends the batterys life and cold cranking capacity.

More engine power

Removes stator load resulting in more engine power.

Optimized power

Optimize power delivery by switching the stator coils on or off.

With  design

This product is an advanced design that lowers operating temperatures for extended longevity and better performance than the OEM part.

Brand new Mosfet Voltage Regulator Rectifier

STOP BURNING YOUR REGULATOR RECTIFIER !
It is time to update or replace your voltage regulator with the advanced MOSFET type.
It runs cooler than all OEM diode style regulators. In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• The quality exceeds the OEM equipment
• Improved heat sink and charging capabilities
• Higher grade of electric components
• All shipped products are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.

Specifications:

Please note: There is two different regulator that fits a CAN-AM Renegade 1000 cc 2015. See specification tab for details. PLEASE VALIDATE THESE MEASUREMENTS WITH YOUR OLD REGULATOR BEFORE BUYING THIS PRODUCT

Dimensions :
Width : 120mm
Length : 111mm
Height: 35mm
Fixation holes center to center : 94mm

Other specifications :
Number of plugs : 2
Number of pins : 5

Warning:

Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Fitment notice:

There are two possible regulators for the Outlander 1000 2012 and many Outlander Max 500 models. This regulator fits mostly the European / International versions of these models. Always check in the 'Fits models' section and please compare to your orig