Brand new aftermarket Stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• Pick up pulsar coil included
• Connectors included
• Rubber grommet included
• All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

Specifications:

Dimensions :
Interior diameter : 42 mm
Exterior diameter : 115 mm
Thickness : 16 mm
Length of wires stator to grommet : 250 mm
Length of wires grommet to plug # 1 : 195 mm
Length of wires grommet to plug # 2 : 500 mm
Length of pickup coil\'s wire to grommet : 280 mm

Other specifications :
Number of wires : 5
Number of plugs : 2
Number of pins : 5
Number of poles : 18

Wire to wire resistance :
Alternator : Between each Black = 0.6 ohms \-20%
Pickup : Green To Grey = 244 ohms \-20%

Warning:

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Stator failure on these Triumph motorcycles often affect the voltage regulator at a point where the defective voltage regulator will cause any new stator installed to fail prematurely. We highly recommend to replace your current voltage regulator with our voltage regulator RMS022-105928. Where RMS900-107277 is the kit that fit the models.

Fitment notice:

Please note That there are multiple possible stators for the 2007 to 2018 Street Triple. This stator will only fits on :

Street Triple Standard This part will only fit Street triple Standard with a VIN HIG